Harbor Breeze ECHOLAKE 00876 Manual Del Usuario página 5

DOWNROD STYLE FAN MOUNTING
3. Loosen the two set screws from the yoke. Slip
downrod assembly (E) into yoke, aligning holes
in downrod assembly (E) and yoke. Insert the
pin through yoke and downrod assembly (E),
then insert clip into pin until it snaps into place.
Tighten set screws. Slide the yoke cover (D)
down over the motor housing (H).
4. Install hanger ball on the top of downrod assembly
(E) into mounting bracket (A) opening. Rotate fan
until slot on hanger ball engages the tab on the
mounting bracket (A).
DANGER: Be careful when aligning the tab
to the slot! If not fully engaged, there is a
possibility of fan falling, which may result in
serious injury or death.
You may now proceed to WIRING page 10.
CLOSEMOUNT STYLE FAN MOUNTING
1. Remove the canopy cover (C) from the bottom
of the canopy (B).
3
Yoke
E
D
Clip
Set screw
Pin
4
Tab
A
E
1
B
Lowes.com/harborbreeze
8
CLOSEMOUNT STYLE FAN MOUNTING
2. Remove every other screw from the top of the
motor housing (H) and save.
H
3. Place the rubber gasket (FF) over the remaining
screws on motor housing (H). Pull wires through
hole in canopy (B), and attach canopy (B)
to motor housing (H) using the three screws
removed in previous step. Tighten the screws
securely.
Slot
Hardware Used
FF Rubber gasket
4. Temporarily hang the canopy (B) onto the hook
on the mounting bracket (A) using one of the
non-slotted holes in the canopy (B). This will
allow for hands-free wiring.
C
2
H
3
H
FF
x 1
4
A
H
B
FF
Lowes.com/harborbreeze
9
B
Hook
B