Final Installation - Harbor Breeze ECHOLAKE 00876 Manual Del Usuario

WIRING
1. Connect the BLACK and BLUE wires from the
fan to the house BLACK wire. Connect the
WHITE wire from fan to the house WHITE wire.
Connect all GROUNDED (GREEN) wires together
from fan to the house GREEN/GROUND wire.
Note: BLACK wire is hot power for fan. BLUE
wire is hot power for light kit in case of future light
kit installation. WHITE wire is common for fan
and light kit. GREEN wire is ground wire. If house
wires are different colors than referred to above,
stop immediately. Consult a licensed electrician to
determine proper wiring.
2. To connect wires, twist wire ends together and
screw wire with wire connectors (AA) in a clockwise
direction. Tape the wire connectors (AA) and wires
together with electrical tape (not included). Be sure
no bare wire or wire strands are visible after making
connection.
Place GREEN and WHITE connections on opposite
side of box from the BLACK and BLUE connections.
The splices should be turned upward and pushed
carefully up into the outlet box.
Hardware Used
AA
Wire Connector x 4

FINAL INSTALLATION

If you installed the fan with "Closemount Style Fan
Mounting", continue to Steps 1 and 2. If you installed
the fan with "Downrod Style Fan Mounting", skip to
Step 3.
1. Remove the fan from the hook on the mounting
bracket (A). Align the locking slots of the canopy
(B) with the two screws previously loosened (step
3, page 6) in the mounting bracket (A). Push up to
engage the slots and turn clockwise to lock in place.
Immediately tighten the two screws firmly.
1
Supply circuit
Ground/Green
White
White
Black
Black
Ground/
Green
Blue
2
AA
1
Outlet
box
A
hook
Locking
slots
B
Lowes.com/harborbreeze
10
FINAL INSTALLATION
2. Re-install the two screws that were previously removed
(step 3, page 6) to fully secure the canopy (B) to the
mounting bracket (A).
You may now proceed to Step 4.
Outlet bo x
GREEN/
GROUND
Speed switch
3. Directly align the locking slots of the canopy (B) with
the two screws previously loosened (step 3, page 6)
in the mounting bracket (A). Push up to engage the
slots and turn clockwise to lock in place. Immediately
tighten the two screws firmly, then re-install the two
screws that were previously removed (step 3, page 6)
to fully secure the canopy (B) to the mounting bracket
(A).
4. Attach blade (G) to a blade bracket (F) using three
blade screws (DD).
Screws
Repeat for remaining blade assemblies.
Hardware Used
Blade Screw
DD
2
Outlet box
B
3
Outlet box
4
DD
x 16
Lowes.com/harborbreeze
11
Screw
Screw
B
THIS SIDE UP
G
F