Important Safeguards - Peter Bausch 0381D Instrucciones Para El Uso

Please, read and follow these instructions of safety before using this appliance. Our
warranty doesn't cover damages and/or injuries caused by non-observance of these safety
norms and instructions. Keep this booklet of instructions in a safe place and adjoin it to the
appliance if or when you should give it away.

IMPORTANT SAFEGUARDS

Danger! Never use the appliance in the bath, or near a water-filled hand-basin.
Risk of a fatal electrical shock!
• Do not let children use the equipment without supervision. Injury and electrical shock hazard!
• Connect the adaptor exclusively to AC mains of 230 Volts ~ 50Hz. Device may ignite spontaneously!
• For cleaning, never immerse the device in water. There's a risk of electrical shock due to
penetrated water!
• Connect the appliance exclusively to the adapter supplied with it. Risk of fire!
• Never bend or squeeze the cable, nor let it get in contact with hot things. Risk of electrical shock due
to damaged cable insulation!
• After each use unplug the adapter from the mains. Risk of fire due to over-heating of the
transformer!
• Before each use check the appliance, in case of damage of any kind avoid using it. Injury and
electrical shock hazard!
• Attention! Do not open or damage the manicure-pedicure device as well as the manicure-pedicure
device by forcefully impacts. Injury and electrical shock hazard!
STARTING UP
Rechargeable batteries are incorporated so that the set can be used cordlessly. Before the first use or
when the batteries are low it is necessary to recharge them for 12 hours with the enclosed adapter (6):
Plug the adapter to the main and connect the set to it with the cable (7). Make sure the set is switched off
(on 0) when loading the batteries. Once the batteries are loaded first unplug the adapter from the main,
then disconnect the set. With loaded batteries the set will work cordlessly approx. 10 minutes according
to the job to be done. You can also use the set with the cable, i.e. connected to the adapter plugged to
the main, when the batteries are low. Avoid absolutely to over discharge the batteries. So after each use
switch off the set so that the motor is no longer connected to the battery.
I
Hold the knurled screw (3) with one hand. Unscrew the nut (4), with your other hand, turning
it in a clockwise direction. Insert the attachment into the location hole (5). To tighten the nut
(4) turn in an anticlockwise direction.
II
Switch on the set at the handle:
Step 1 = low speed / step 2 = high speed / central position = OFF