Important Safeguards; Cleaning And Maintenance - Peter Bausch 0356 Instrucciones Para El Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 7
Please, read and follow these instructions of safety before using this appliance.
Our warranty doesn't cover damages and/or injuries caused by non-observance of these
safety norms and instructions. Keep this booklet of instructions in a safe place and adjoin it to the
appliance if or when you should give it away.
IMPORTANT SAFEGUARDS
Danger! Never use the appliance in the bath, or near a water-filled hand-basin.
Risk of a fatal electrical shock!
Do not let children use the equipment without supervision. Injury and electrical shock hazard!
Connect the adaptor exclusively to AC mains of 230 Volts ~ 50Hz. Device may ignite spontaneously!
For cleaning, never immerse the device in water. There's a risk of electrical shock due
to penetrated water!
Connect the appliance exclusively to the adapter supplied with it. Risk of fire!
Never bend or squeeze the cable, nor let it get in contact with hot things. Risk of electrical shock due to
damaged cable insulation!
After each use unplug the adapter from the mains. Risk of fire due to over-heating of
the transformer!
Before each use check the appliance, in case of damage of any kind avoid using it.
Injury and electrical shock hazard!
ATTENTION! Do not open or damage the device as well as the pedicure device by forcefully impacts. Injury
and electrical shock hazard!
STARTING UP
I
H old the knurled screw (1) with your hand. To remove the nut (2) use your
other hand to turn it in a clockwise direction.The attachment is inserted
into the location hole (3). To tighten the nut (2) turn in an anticlockwise
direction.
C onnect the appliance to the adapter (5) with the small plug (6), conforming
II
the poles (+/-). The pilot lamp (9) indicates proper connexion to mains. Adjust
he speed of rotation: speed 1 (3 V) and 2 (4.5 V) = slow / speed 3 (6 V) and
4 (7.5 V) = middle / speed 5 (9 V) and 6 (12 V) = fast. Attention please: the
transformer needs to work with 12 V, 9 V or 7.5 V to light the LEDs. Other
voltages: the power supply is not high enough to light the LEDs.
III
T urn on at the switch on the handle.
USE OF THE ACCESSORIES
Hands and feet can be treated a lot easier after a warm bath (with or without additives). Nails are then more
flexible, and hard skin is easier to remove.
a
Pointed abrasive tip: for shortening and shaping finger and toe-nails.
b
Cylindrical abrasive tip: to remove hard skin from fingertips, toes,
heels and sole.
c
Felt polishing tip: to polish the nails prior to application of lacquer.
Using regularly this polisher will prevent nails to split or break.
d
Diamond cutter ball: for removing corns and partridge eyes.
e
Diamond cutter flame shaped: for dealing with ingrained nails as well as for
removing the not very aesthetic cuticles around the nails..
f
Diamond cutter: for the removal of horny skin or corns and partridge eyes.
g
Diamond cutter cylinder: for shortening and shaping finger and toe-nails.
h
Abrasive thimble with arbor: for removing callosity on heel, toes and sole.
CLEANING AND MAINTENANCE
For cleaning just wipe the manicure/pedicure appliance with a dry, soft cloth. Don't ever put
the set in water or use detergents. Except for the polishing felt and the brush, you can use water, soap and a
brush to clean the other accessories. After the cleaning it is advisable to spray on a disinfectant. Let the tips dry
in order to avoid rusting. The set needs no maintenance, just take good care of it.
REPAIRS
Caution! Electrical appliances shouldonly be repaired by qualified technicians, asotherwise
serious damage may be caused.
WASTE DISPOSAL
At the end of its working life the appliance must not be disposed of as urban waste. It must
be taken to a special local authority differential waste collection centre for electrical and
electronic products.

Publicidad

Tabla de contenido
loading

Tabla de contenido