Fitting The Sanding Sheet Onto The Sanding Plate; Changing Tools - Parkside PAMFW 20-Li A1 Traducción Del Manual De Instrucciones Original

Application
–
removing material residues, such as tile
adhesive, when replacing damaged tiles
–
milling grout on wall and floor tiles.
Scraper
Materials
mortar/concrete residues, tile/carpet glue, paint/
silicone residues
Application
–
removing material residues, such as carpet glue
residue on the floor.
Sanding plate
Materials
Wood and metal (sanding sheets
wood*, metal*
* Depending on the sanding sheet
Application
–
sanding up to edges and hard-to-reach areas.
PAMFW 20-Li A1
Fitting the sanding sheet onto the
sanding plate
♦ Place the sanding sheet
sanding plate

Changing tools

NOTE
►
■
♦ If necessary, remove an already fitted tool.
To do this, raise the tool release lever
♦ Fit the tool (e.g. the plunge saw blade
the tool holder.
NOTE
►
♦ Lock the tool into place by pushing the tool
release lever
■ Check that the tool is fitted firmly. Incorrectly
or insecurely fitted tools can come loose during
use and cause you an injury.
supplied),
.
If you plan to use the dust extraction unit, it
must be connected before fitting or changing
the tool (see. section "Connecting a dust
extraction unit").
WARNING! RISK OF INJURY!
Always remove the battery before working on
the power tool.
You can fit the tools in any snap position on
the tool holder.
back down again.
centrally on the
.
) onto
GB │ MT │
51 ■