Installing Flat Panel Screen; Adjusting Mount Extension - PEERLESS Paramount PC930A Manual Del Usuario

Attaching Screen
Guide hook slots of tilt bracket (F) onto M5 x 10 mm screws (J) in swivel/pivot bracket (E) as shown in figure 7.1.
7
Thread two M5 x 10 mm screws (J) through tilt slot of tilt bracket (F) into swivel/pivot bracket (E) as shown in
figure 7.2. Do not fully tighten screws to allow for tilt adjustments. Tilt slot allows for incremental tilts of 5°.
Adjust tilt of screen and fully tighten all four M5 x 10 mm screws (J) as shown in figure 7.3.
• Do not lift more weight than you can handle. Use additional man power or mechanical lifting equipment to safely
handle placement of the screen.
fig. 7.1
F

Adjusting Mount Extension

While supporting the weight of the screen, loosen
8
screws (L) on clamp plate (D) half a turn and
position screen to the desired height.
Retighten clamp plate screws securely.
WARNING
• Clamp plate adjustment screws support weight of
screen when fully tightened. Weight of the screen will
need to be supported if clamp plate screws are
loosened.
Visit the Peerless Web Site at www.peerlessmounts.com
J
HOOK
SLOTS
E
WARNING
TILT
SLOTS
F
J
fig. 7.2
CLAMP PLATE
SCREWS
10 of 33
fig. 7.3
E
D
L
ISSUED: 11-29-07 SHEET #: 202-9263-1
For customer care call 1-800-865-2112 or 708-865-8870.
J