Adjusting Screen; Install Cable Covers - PEERLESS Paramount PC930A Manual Del Usuario

Adjusting Screen

If screws indicated are fully tightened, loosen screws half a turn to allow for adjusting tilt, swivel and roll. Adjust
9
screen to the desired position and fully tighten screws.
• Do not loosen adjustment screws to the point they become disengaged from the mount. Weight of the screen should
be supported in case of accidental disengagement.
ROLL ADJUSTMENT
BACK VIEW
SCREWS FOR ROLL
ADJUSTMENT
6° (±3°) ROLL

Install Cable Covers

Note: Be certain mount is in the desired
10
extended position.
Attach cables to screen if routed through
channels.
Cut cable covers (G) to the length of inner
channel (C) and outer channel (B) openings,
leaving space for cables if routed through
channels. Snap cable covers into openings as
shown.
Cables not routed through channels will require
cable ties (not included).
Visit the Peerless Web Site at www.peerlessmounts.com
WARNING
TILT ADJUSTMENT
SIDE VIEW
SCREWS FOR TILT
ADJUSTMENT
(BOTH SIDES)
SLOT ALLOWS FOR
INCREMENTAL TILT
ADJUSTMENTS OF 5°
30° (+25°/-5°) TILT
11 of 33
All other brand and product names are trademarks or registered trademarks of their respective owners.
SWIVEL ADJUSTMENT
BOTTOM VIEW
SCREWS FOR SWIVEL ADJUSTMENT
90° (±45°) SWIVEL
G
CUT TO
LENGTH OF
OPENING
C
ISSUED: 11-29-07 SHEET #: 202-9263-1
For customer care call 1-800-865-2112 or 708-865-8870.
© 2008, Peerless Industries, Inc. All rights reserved.
B
G
CUT TO
LENGTH OF
OPENING