Installing Inner Channel And Routing Cables - PEERLESS Paramount PC930A Manual Del Usuario

Installing Inner Channel and Routing Cables

Note: Be certain holes on inner channel (C) face
3
in the same direction of opening on outer
channel (B).
Note: Cables must be removed from screen
before routing through channels. If cables are not
removable from screen, routing through channels
is not an option.
Guide screen cables into openings in channels
then insert inner channel (C) into outer channel
(B) as shown in figure 3.1.
Position inner channel (C) to the desired height
and secure using two M6 x 12 mm socket pin
screws (L) through clamp plate (D), through
opening in outer channel (B) and into inner
channel (C) as shown in figure 3.2.
Insert swivel/pivot bracket (E) into end of inner channel (C) and secure with four M5 x 10 mm socket pin screws (J) as
4
shown in figure 4.1 and figure 4.2.
Thread two M5 x 10 mm screws (J) into top holes of swivel/pivot bracket (E), leaving 1/8" (3 mm) exposed thread
between head of screw and swivel/pivot bracket as shown in figure 4.3.
fig. 4.1
C
E
Visit the Peerless Web Site at www.peerlessmounts.com
OPENING
HOLES
C
CABLES NOT SHOWN FOR CLARITY
fig. 4.2
E
7 of 33
fig. 3.1
B
L
GUIDE
CABLES IN
CHANNELS
fig. 4.3
J
C
E
J
1/8"
(3 mm)
FRONT VIEW
ISSUED: 11-29-07 SHEET #: 202-9263-1
For customer care call 1-800-865-2112 or 708-865-8870.
fig. 3.2
D
B
C
E
J
1/8"
(3 mm)