Tabla De Contenido; Tools Needed For Assembly - PEERLESS SUF660P Instalación Y Ensamblaje

Soporte plano slimline ultra-thin para pantallas planas lcd de 37" a 65"
Ocultar thumbs Ver también para SUF660P:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

NoTe: Read entire instruction sheet before you start installation and assembly.
• Do not begin to install your Peerless product until you have read and understood the instructions and warnings
contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please
call Peerless customer care at 1-800-865-2112.
• This mount is designed to attach the screen 0.4" from the wall. Please refer to manufacturer's installation guide
recommendations for required distance from wall to avoid risk of injury or property damage.
• This product should only be installed by someone of good mechanical aptitude, has experience with basic building
construction, and fully understands these instructions.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached hard-
ware and components.
• Never exceed the Maximum UL Load Capacity. See page 1.
• If mounting to wood wall studs, make sure that mounting screws are anchored into the center of the studs. Use of
an "edge to edge" stud finder is highly recommended.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding
power.
• This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal
injury.
• This product was designed and intended to be mounted to the following supporting surfaces checked below with
the hardware included in this product as specified in the installation sheet. To mount this product to an alternative
supporting surface, contact Peerless customer care at 1-800-865-2112.
• This product was designed to be installed on the following wall construction only;
WALL CoNSTRUCTIoN
x
Wood Stud
x
Wood Beam
x
Solid Concrete
x
Cinder Block
Metal Stud
Brick
Other or unsure?

Tools Needed for Assembly

• stud finder ("edge to edge" stud finder is recommended)
• phillips screwdriver
• drill
• 5/32" bit for wood stud wall
• level
Table of Contents
Parts List.................................................................................................................................................................................3
Installation to Wood Stud Wall ................................................................................................................................................4
Installation to Solid Concrete/Cinder Block walls ...................................................................................................................5
Installing Adapter Brackets .....................................................................................................................................................6
Mounting and Removing Flat Panel Screen ...........................................................................................................................8
Visit the Peerless Web Site at www.peerlessmounts.com
WARNING
ADDITIoNAL HARDWARe ReQUIReD
None
None
Contact Customer Service
Contact Customer Service
Do not attach except with Peerless accessory kit for metal studs;
Contact Customer Service for Peerless accessory kit for metal studs.
Contact Customer Service
Contact Customer Service
2 of 24
ISSUED: 05-29-08 SHEET #: 202-9283-3 08-6-08
For customer care call 1-800-865-2112 or 708-865-8870.

Publicidad

Tabla de contenido
loading

Tabla de contenido