Installation; Cautions; Rack Mounting; Input Connections - Optimus AM-120Z Manual De Instalación Y Funcionamiento

AM-120Z
Amplifier

3. INSTALLATION

3.1. Cautions

Before you begin, make sure your mixer-amplifier is disconnected from the power source, with the
power switch in the OFF position and all level controls turned completely down (counterclockwise).
Keep enough space among equipments to ensure a correct convection cooling.

3.2. Rack mounting

1. Locate the two rack ears and six rack-ear screws supplied.
2. Place a rack-ear on the right front of the chassis.
3. Insert the screws into the holes of the rack-ear and chassis. Screw them in.
4. Repeat steps 2 to 5 for the left side of the chassis.
5. Remove the four legs from bottom of unit.
Please refer to the following figure.

3.3. Input connections

The following figures show pin assignments for each cable type. RCA input connectors can be
used for unbalanced inputs.
Page 5 of 17
AM-120Z Version 1.0