KNOVA KN RXW-10M2 Manual Del Usuario página 11

ASSEMBLE AND ADJUSTMENTS
ASSEMMBLE THE BLADE GUARD:
1. Before installation the blade guard (N), please confirmed
Fig.18 the handle (M) keep on open as Fig.19.
O
2. Pull up the guards as Fig.18.
3. Insert the guards on the position O & P of spreader
as Fig.18.
Fig. 19
4. Put down the guards(N) as Fig.20 and lock
the handle(M), then fix the handle(M) as Fig.21.
Fig. 20
M
N
P
Fig. 18
M
M
N
Fig. 21
CHECK THE 45º SETTING.
Tilt the blade with the bevel hand wheel as far as it will go
to the left. Place the square against the blade (be sure the
square is not against one of the saw teeth). If the blade is
not at 45º, unscrew the 45º stop screw, turn the hand wheel
until the blade is correct, and tighten the screw. Recheck and
repeat it necessary.
Check that the scale indicator is at 45º.
If not, loosen the scale indicator with a screwdriver, adjust it
within the slot, and retighten the screw.
10
M
Fig. 22