KNOVA KN RXW-10M2 Manual Del Usuario página 7

MACHINE LEGEND
MITER GAUGE – This gage aligns the wood for a crosscut.
The easy-to-read indicator shows the exact angle for a miter
cut, with positive stops at 90º and 45º .
MITER GAUGE GROOVES – The miter gage rides in these
grooves on either side of the blade.
RAILS – Front and rear rails provide support for large work
pieces and the rip fence.
RIP FENCE – A sturdy metal fence guides the workpiece and
is secured with the rip fence handle.
Grooves run along the top and sides of the rip fence for use
with optional clamps and accessories.
RIP FENCE HANDLE – The handle on the front of the rip
fence releases the rip fence or locks it in place.
Riving knive 2.3 mm thick
for use with 10" blade
Body: 2.1 mm ~ 2.3 mm
Kerf: 2.8 mm ~ 3.5 mm
3. Dust collecting hole located on the bottom of stand:
Dust
collecting
hole
RIVING KNIFE OR SPREADER – Located directly behind
the blade, it keeps cut edges from binding and supports the
blade guard.
SCALE – Found on the front rail, the easy–to–read scale pro-
vides precise measurements in rip cuts.
EXTENSIONS WINGS – Removable stamped steel exten-
sions, 12 in. By 27 in., support larger work pieces.
WARNING
1. Be sure to use only blades rated for at least
2. Please use the standard blade according to
Spreader 2.3 mm thick for
use with 10" blade
Body: 2.1 mm ~ 2.3 mm
Fig. 2-2
Kerf: 2.8 mm ~ 3.5 mm
6
4,200 r.p.m. and recommended for use on this saw.
the specification mark on the blade as
Fig.2-2 & Fig.2-3:
Fig. 2-3
Fig. 2-4