Cub Cadet CC 30 Manual Del Operador página 11

5. Tighten the shoulder bolt and lock nut using a 9/16"
wrench or socket and 7/16"wrench or socket.
6. Remove the pedestal cap mount screw factory installed
and located on the tractor's steering console. Retain the
screw for later instructions.
7. Slide the pedestal cap down onto the tractor (1) and slighty
rotate to the right to clip into place. Secure the pedestal
with the screw (2) previously removed. See Figure 3-3.
2
Figure 3-3
Attaching the Seat
If the seat for your tractor was not attached at the factory, follow
the applicable instructions below to attach it.
1. Remove the shoulder bolts and lock nuts from the seat
mounting bracket included in your hardware pack. See
Figure 3-4.
Figure 3-4
2. Remove the two self-tapping bolts factory installed on the
tractor. See Figure 3-5.
1
Figure 3-5
3. Align the seat bracket in place over the holes from where
the self-tapping bolts were removed, as shown in
Figure 3-6.
4. Using a 1/4-inch drive ratchet with a 3/8" socket, secure the
seat bracket with the self-tapping bolts removed in step 2.
See Figure 3-6.
Figure 3-6
CAUTION:
Do not use any type of power tool (e.g.
impact gun or electric drill with nut driver attached)
when tightening the self-tapping bolts to attach the
seat bracket.
5. Position the seat assembly over the seat mounting bracket,
aligning the holes provided.
S
ection
3 — A & S -U
SSembly et p
11 11