Jacuzzi DESIGNER Serie Instalación, Uso, Mantenimiento página 14

Refer to the user manual of the tub for how to use the
hydromassage.
u Switch on the device: the readout will light up and turn
white.
u The blue "fill tub" button (R) will light up and the system
will be ready to receive commands. A coloured bar (L) (LEDs)
will appear on the right to display the stored temperature (the
default temperature is 38°C).
The readout will be turned off and the system will return to
"stand-by" mode if no button is pressed in two minutes. During this
time, the system will automatically activate the check procedures
to prepare for operation. After this step, simply touch any button to
activate the system again.
The water temperature can be adjusted in a range from a minimum
temperature of 25°C to a maximum temperature of 50°C (the default
temperature is 38°C).
A different setting from the default temperature can be
stored:
- select the new temperature using the "arrow up" or "arrow down"
buttons, then hold both buttons pressed for approximately 2
seconds. The buttons will start blinking to indicate that the new
selected temperature has been stored.
u Turn on the system as shown in the corresponding section, if
required.
u Press the "arrow up" button to increase the water temperature
(the next LED will light up).
Press the "arrow down" button to decrease the temperature (the
last LED will go out)
u The three red LEDs will blink when the water temperature
reaches 38°C: this indicates that the safety block is on.
Hold the "arrow up" button pressed until it stops blinking and
a red LED stays on to select a higher temperature: you can now
increase the temperature as required.
■
u Press the "arrow down" button until only the first blue LED
stays on (corresponding to 36°C).
u Press the button to reach a temperature cooler than 25 °C,
considering that each pressing of the button corresponds to a
temperature variation of 1°C.
The LEDs display temperatures from 36°C to 40°C. Variations
of temperatures not included in this range are indicated as follows:
- If the temperature is lower than 36° C, the first blue LED will stay on
and will go out when the "arrow down" button is pressed to indicate
that a temperature lower than 36 °C is being selected (each pressing
of the button corresponds to a temperature variation of 1°C).
- All LEDs will light up if a temperature higher than 40°C is being
selected but the last red LED will go out briefly when the "arrow up"
button is pressed thus indicating that you are selecting a temperature
higher than 40°C (each pressing of the button corresponds to a
temperature variation of 1°C).
14 14