Jacuzzi DESIGNER Serie Instalación, Uso, Mantenimiento página 16

- Press the "on/off" button again to interrupt the procedure. Filling
will resume from the point in which it was interrupted within one
minute. Otherwise, the procedure will be definitively deleted.
- Pick up the hand shower and press the "shower" button to interrupt
the filling operation and make water available at the hand shower
(see corresponding section). You can press the "fill tub" button within
one minute to resume filling the tub.
- If you realise that the chosen level is not the level you require
while the tub is being filled (automatic filling operation) you can
choose a new level by pressing the "fill tub" button, as previously
shown. This function is also useful after filling for adding water into
the tub.
- The filling level which has been reached will not be stored after a
power blackout. Add water to obtain the required level.
■
Simply press the "on-off" button to add water or change the
temperature by adding hotter or colder water, (check that the system
is on: the blue "fill tub" and "on/off" buttons must be on and the
level indicating LEDs must be off): water will be poured for a
maximum time of approximately two minutes (press the same
button to stop or continue).
The hand shower integrated in the tap and fitting unit can be
operated for a maximum time of approximately two minutes (press
the same button to stop or continue).
u Turn the system on, if necessary (see "Turning on").
u Take the hand shower pulling it upwards to extract the
flexible hose (located under the tub).
u Then press the "shower" button (D).
u Press the "on-off" button to start filling. Water will start
coming from the shower head
u Adjust the temperature, if required, as shown in the
corresponding section.
u The icon will go out once the function has ended (two
minutes after starting or after having pressed the corresponding
button again). Then put the hand shower back in its seat so that
the sensor (S) is entirely covered.
S
- Press the "fill tub" button while the hand shower is running to
close the hand shower and divert the water to the tub filler.
- The "shower" function may only be operated when the hand
shower is lifted from its seat. This applies also when filling the
tub from the filler and the ìshowerî button is pressed (it will blink
rapidly in this case).
- Check that the hand shower is positioned correctly and intercepts
the sensor to prevent water from accidentally running from the
hand shower.
16 16