Jacuzzi DESIGNER Serie Instalación, Uso, Mantenimiento página 15

The tub can be filled automatically using the control parameters
stored by the system. The parameters must be customised to your
needs after installation because the tub capacity changes from
model to model.
Three filling levels are available, each indicated on the display by
corresponding LEDs (arranged by the side of the "fill tub" button):
- minimum (A)
- medium (B)
- maximum (C) which corresponds to the level sensor position.
The minimum level corresponds to 1/3 of the maximum level, while
the medium level corresponds to 2/3.
The system will automatically calculate the time needed to reach
the other levels after having filled the tub to the maximum level.
■
u Make sure that the drain is closed and that the system is on
(see "Turning on").
u THold both buttons pressed at the same time for
approximately two seconds: the LEDs by the side of the "fill tub"
button will start blinking.
u Hold the "on/off" button pressed within three seconds from
when the LEDs start blinking (the LEDs will continue to blink)
until the tub starts filling.
Start again from the beginning if the you are late pressing
the button.
u When the maximum filling level is reached, the level
indicating LEDs will stop blinking, the "on/off" button will
go out when the water flow stops. The three levels are
automatically calculated and stored.
- Adjust the temperature, if required, as shown in the corresponding
section.
- The filling level will not be stored after a power blackout. Repeat
the level storage procedure from the beginning.
■
Proceed as follows after having established the filling levels
whenever you use the tub:
u Make sure that the drain is closed and that the system is on
(see "Turning on").
u Now press the "fill tub" button:
- to select the minimum stored level (the first LED on the
bottom to the left of the button will light up).
- to select the medium stored level (the second LED will also
light up).
- to select the maximum stored level (the third LED
will also light up).
- Press the "fill button" button again: all LEDs will go out and the
"top-up" function (see corresponding section) will be available.
Repeat the procedure from the beginning to go back to the
automatic filling function.
u Press the "on-off" button to start filling.
u Adjust the temperature, if required, as shown in the
corresponding section.
u When the chosen temperature level is reached, filling will stop
and the LEDs will stop blinking (expect for when the maximum
level is reached). Filling may continue using the "top-up" function
(see corresponding section) or the hand shower.
15 15