Interior Lighting - Sub-Zero 700TR Manual Del Usuario

OPERATION

Interior Lighting

WARNING
Turn power off at the control panel before replacing light
bulbs. Wear protective gloves when handling bulbs.
OVERHEAD LIGHTING
Column and tall | Overhead lighting uses 40-watt bulbs.
To access bulbs, remove the light shield by releasing the
locking clip from each side of the light shield. Hold the
bottom of the shield then slide back until the slots are
aligned with the wall studs. To reinstall, align slots with
studs then slide forward. Once in position, rotate locking
clips back into position. Refer to the illustrations below.
LIGHT LOCKING CLIP
SHIELD
Overhead lighting—column.
|
10 Sub-Zero Customer Care 800.222.7820
LIGHT LOCKING CLIP
SHIELD
Overhead lighting—tall.
REFRIGERATOR DRAWER LIGHTING
Column | Drawer lighting uses 40-watt bulbs. To access
bulbs, remove the drawer and glass shelf, then slide light
shield up to remove. To reinstall light shield, place over
bulbs then slide down into position. Reinstall drawer and
glass shelf. Refer to the illustration below.
STORAGE DRAWER LIGHTING
Tall and drawer | Drawer lighting uses a 25-watt bulb. The
bulb is recessed into the top of each drawer compartment.
To access the bulb, pull the drawer forward until it stops or
remove completely by lifting up and out. Refer to the illus-
tration below.
Refrigerator drawer lighting.
RECESSED BULB
Storage drawer lighting.