Ice Maker Operation; Drawer Removal - Sub-Zero 700TR Manual Del Usuario

OPERATION
Storage Drawers

DRAWER REMOVAL

To remove, pull the storage drawer forward until it stops.
Lift the front of the drawer slightly and pull straight out. To
reinstall, place drawer onto the slides, then align the holes at
the front of the drawer with the pegs on the slides. Refer to
the illustration below.
For drawer models, the upper drawer has a control cable
that must be disconnected before removing the drawer.
Refer to the illustration below.
PEG
Storage drawer removal. Control cable (drawer models).

Ice Maker Operation

To initiate ice production, touch ICE on the control panel. To
deactivate, touch ICE again. After initial start-up, discard the
first few batches of ice. The ice may contain impurities from
new plumbing connections.
The ice maker will cycle (eight cubes) every two hours. If ice
is not used regularly it may fuse together. To avoid, discard
ice and allow ice maker to replenish.
For column models, the ice maker must be turned off at the
control panel when the ice container is removed. For tall and
drawer models, the ice maker is deactivated when the ice
container is removed. Ice production will resume when the
container is reinstalled.
Sabbath
This appliance is certified by Star-K to meet strict religious
regulations in conjunction with specific instructions found
on www.star-k.org.
Column and tall models may require a wire harness kit to ini-
tiate Sabbath mode. The kit is available through your autho-
rized Sub-Zero dealer. For local dealer information, visit the
find a showroom section of our website, subzero.com.
To initiate Sabbath mode, while the unit is on, touch POWER
on the control panel. 'OFF' appears in the control panel dis-
play. Touch and hold POWER for 10 seconds until the lights
turn off, indicating Sabbath mode has been initiated. Lights,
ice maker (if applicable) and door alarm will be disabled. To
return to normal operating conditions, touch POWER.
|
subzero.com 9