Pari LC Sprint Instrucciones De Uso página 7

D. CLEANING YOUR PARI REUSABLE NEBULIZER
1. Disconnect the tubing from the air intake on
the bottom of the nebulizer cup.
2. If there is any moisture (condensation) in the
tubing, let the compressor run with only the
tubing attached for 2-3 minutes. The warm
air from the compressor will dry out the
tubing. Alternatively, you can dry the tubing
by removing it from the compressor and
hanging it up with the "ends down" to allow
any moisture (condensation) to drain out
and evaporate. Use a clean damp cloth to
wipe the exterior of the tubing.
3. Disassemble reusable nebulizer parts as
illustrated on page 3.
4. Wash all parts with warm water and liquid
dish soap. DO NOT WASH THE TUBING.
5. Rinse the reusable nebulizer parts thoroughly
with warm water and shake out water.
6. Air dry or hand dry nebulizer parts on a
clean, lint-free cloth. Reassemble nebulizer
when parts are dry and store.
7. You can also wash all parts of the reusable
nebulizer on the top shelf of a dishwasher.
DO NOT WASH TUBING. Place the
reusable nebulizer parts in a dishwasher
C
basket, then place the basket on the top rack
of the dishwasher. Remove and dry the parts
when the dishwasher cycle is complete.
WARNING
TO REDUCE RISK OF INFECTION:
1. Nebulizer for single patient use (one person)
only. Do not share your nebulizer with other
patients.
2. You must regularly disinfect or sterilize the
nebulizer between treatments. Failure to do
so could lead to serious or fatal illness.
E. DISINFECTING YOUR PARI
REUSABLE NEBULIZER
1. Clean the nebulizer as described in Section
D. For low-level disinfection every other
treatment day, soak all parts of the PARI
Reusable Nebulizer (except tubing and mask)
in a solution of 1 part distilled white vinegar
and 3 parts hot tap water for 1 hour. You can
substitute respiratory equipment disinfectant
(like Control III
(follow manufacturer's instructions for
mixing).
D
Questions? 1.800.FAST.NEB (327.8632) | PARI.com 5
) for distilled white vinegar
®