Diamond TG 12 Manual De Instruccion página 31

FUNCTIONING DESCRIPTION
The control devices are designed and manufactured so as much sure and reliable and resistant to the service normal stresses, to
the foreseeable strains and to the external agents. Besides they are clearly visible, locatable and marked from a suitable
marking. Here follow the main control devices are showed:
TYPE / COLOR
button / black
"0" / button for the machine stop control
Button / white
"I" / button for the machine start control
STARTING
The machine starting is possible only with a voluntary action on the control device foreseen for this aim: white button "I"
for the machine starting control.
STOP
For the stop control push the black button "0". In case of momentary or extended stop, before to get in function the machine,
all food products must be removed within the machine: follow the indications relative to the grinding group disassembly.
FUNCTIONING SAFETY
If the machine is under stress, or is submitted to too long functioning times or submitted at overloaded, the same stops
immediately for the thermal protection functioning. In this case wait that it is completely cooled before proceeding to the
starting function.
VOLTAGE LACKING
In case of electric feeding breaking or if the machine is disconnected from the electric net, this last one will be able to be
restarted only following the starting function, after the electric feeding back or the reconnection to the electric net.
PRESSURE OPENING
Lifting for the handle the pressure of the grater group, the machine stops immediately for the safety micro switch functioning.
The machine can be restarted only lowering the pressure up to the height that doesn't allow the fingers introduction towards
the grater roll and following successively the starting function.
CONTROLS AND VERIFICATIONS BEFORE STARTING
VERIFICATION / CONTROL
Check that:
Extraneous objects aren't on the machine, inside the
hopper, inside the machine neck, inside the grater
mouth and in correspondence of the exile zone of the
grated product
Check the cleaning:
Of the machine neck internal parts and of the
grinding group
Of the pusher
of the grater mouth, of the pressure and the grater
roll
of the machine external surface
Check the integrity:
of the fixed protections,
of the loading hopper,
of the machine neck,
of the grater mouth, the pressure and the grater roll
of the machine body
Check the functionality:
of the control system parts / safety control;
Of the control devices.
Check the absence:
Of strange noises after the starting
Check the absence:
Of oil trails both on the machine support ground
both in the Archimedean screw
03-2008-TRITACARNE-GRAT-STAMPA.doc
REFERENCE / DESCRIPTION
MODALITY AND CHECKS
Sight control of the indicated parts, to check of objects or extraneous bodies
lacking as for example different tools, clothes, etc... and that there isn't
however the food product.
In case of presence, provide with their removal.
All indicated parts surfaces, before the machine use must be checked visually
to verify their cleaning.
For the sight check of the grinding group internal parts, provide with its
disassembly.
In case of molds presence or other type of dirtiness, provide with the cleaning
procedure in accordance with the chapter 5 indications
All fixed protections, etc.., must perform the function for which have been
foreseen.
Indicated parts sight check to verify their integrity in their surface external
part.
The parts must be however changed at the first erosion signals or breaking.
All devices must perform the function for which have been foreseen. Control
directly the devices so that these ones determine the waiting function.
The actuators and all parts must be however changed to the first erosion signals
or breaking.
During the functionality checking of the control devices, if there are strange
noises, due for example to a seizing or mechanical breaks stop immediately the
machine and activate the maintenance service.
Both during the working, both at the end of every work, both in the assembly
moment of the grinding group; check the oil trails absence in the indicated
parts. If there are some fluid drops stop immediately the machine and activate
the maintenance service.
Pag. di
12 12