Switching Off - Diamond TG 12 Manual De Instruccion

For any intervention type or for the parts change that are damaged, activate the maintenance service. The possible change
must happen with manufacturer original products or at least of quality, safety and equivalent characteristics. For analysis
contact the Authorized Assistance Center.
PUT IN FUNCTION
The machine operator can put in function the machine following in order the under reported indications:
1. Controls positive result for the preparation preliminary operations,
2. Controls positive result for the electric feeding,
3. Plug connection in opportune current socket,
4. For the functioning of the GRINDING GROUP:
a. Checks positive result for the grinding group assembly,
b. Checks positive result for the Archimedean screw correct rotation,
c. Checks positive result / verifications before starting,
d. Finalized checks positive result and verify the all safety conditions respect,
e. Lower in its lowest position the pressure handle of the grater group,
f. Place a gathering basin in the machine anterior zone in correspondence of the ground meat exit zone,
g. Put in the machine left side and start the machine acting the control device of start "I",
h. Introduce manually the food product within the machine neck and drive it towards the Archimedean screw using
the pestle in equipment,
i. At the end of the food product introduction, or when from the drilled plate doesn't come out more the product,
stop the machine acting the control device of stop "0".
5. For the functioning of the GRATER GROUP:
a. Grinding group disassembly,
b. Checks positive result for the grater roll correct rotation,
c. Checks positive result / verifications before the starting,
d. Finalized checks positive result and verify the all safety conditions respect,
e. Place a gathering basin in the machine anterior zone in correspondence of the grated product exit zone,
f. Put in the machine left side and start the machine acting the control device of start "I",
g. Introduce manually the food product within the grater mouth and drive it towards the grater roll lowering the
pressure roll,
h. At the end of the food product introduction, or when in the basins the product is not more left, stop the machine
acting the control device of stop "0".
It is recommended to make not work the machine in vain, without the food product.
It is recommended to make not work the grater group, with the assembled grinding group.

SWITCHING OFF

In succession, the switching off must follow what here under indicated:
1. Before the switching off wait the food product exile conclusion from the drilled plate or in the grater roll inferior zone,
2. Stop the machine acting the control device of stop "0",
3. Disconnect the machine plug from the feeding socket,
4. Perform the cleaning interventions.
UNBLOCK IN CASE OF OBSTACLE
During the working, or during the Archimedean screw rotation or of the grater group, due to:
1. The introduction of food products with not homogeneous parts, as for example bones, or other,
2. The introduction of products excessively hard and dry,
the machine could block.
The same situation can determine after an electric feeding break, or when the machine is stopped with inside the food product.
To be able to resume normally the working:
1. If the block is happened in the grinding group, this must be disassembled: the disassembly must not happen slacking
the blockage wheel, but slacking the grinding mouth block knob,
2. If the block is happened in the grater roll, the blocked food product must be removed manually.
03-2008-TRITACARNE-GRAT-STAMPA.doc
Pag. di
13 13