Sanus BFV846 Manual Del Usuario página 21

Wood Stud Wall Mounting
CAUTION:
Improper use could reduce the holding power of the lag bolt. To avoid potential injuries or property
damage:
 Pilot holes MUST be drilled to a depth of 75 mm (3 in.), using a 5.5 mm (7/32 in.) diameter drill bit.
 DO NOT over-tighten the lag bolts
 Any material covering the wall must not exceed 16 mm (5/8 in.).
 Minimum wood stud size: common 2 x 4 in. (nominal 1½ x 3½ in.).
Step 1
≤ 16 mm
(5/8 in.)
Locate studs. Verify the
center of the stud with an
awl or thin nail or use an
edge to edge stud finder.
Step 3
Drill pilot holes as
illustrated.
42
.
18 x1
406 mm
(16 in.)
75 mm
(3 in.)
OPT
5/16 x 2¾ in.
42 x4
Step 2
Level the wall plate
mark the hole locations.
Step 4
42
Tighten the lag bolts
42
only until the
43
washers are pulled
firmly against the wall
18
plate .
21
43 x4
18
and
18
43
18