Sanus BFV846 Manual Del Usuario página 22

Solid Concrete and
Concrete Block Wall Mounting
CAUTION:
Improper use could reduce the holding power of the lag bolt. To avoid potential injuries or property
damage:
 Pilot holes MUST be drilled to a depth of 75 mm (3 in.), using a 10 mm (3/8 in.) diameter drill bit.
 Be sure the anchors
 Mount wall plate directly onto the concrete surface.
 Never drill into the mortar between blocks.
 DO NOT over-tighten the lag bolts
 Minimum solid concrete thickness: 8 in.
 Minimum concrete block size: 8 x 8 x 16 in.
 Minimum horizontal space between fasteners: 406 mm (16 in.)
18
Step 1
18
18
Level wall plate and
mark the hole locations.
Step 3
Insert lag bolt anchors
44
seat flush with the concrete surface.
42
.
x1
406 mm
(16 in.)
44
44
5/16 x 2¾ in.
42
43 x4
Step 2
Step 4
42
Tighten the lag bolts
until the washers
.
firmly against the wall plate
22
OPT
x4
44 x4
Drill pilot holes as
illustrated.
43
42
only
43
are pulled
18
75 mm
(3 in.)
18
.