Start Up; Speed Control - Truper LIOR-1/2NX Instructivo

Sand Paper Installation
• Select the appropriate sand paper grain.
• Available grains vary from very coarse to very fine.
• The coarse grain is used to sand on rough surfaces. The
medium grain is used for light jobs and the fine grain is used for
finishing jobs.
• It is advisable to make tests on a piece of scrap work piece
piece to determine the right grain for each particular job.
• Do not use the same sand paper for wood and for metal.
Metal particles can be embedded in the sand paper and ruin
the wood surface.
Sand paper installation (A).
• Release the sand paper brackets on both sides of the sander.
• Insert the end of the sand paper under one of the brackets
and secure. Pull the other edge so that the sand paper sits
evenly onto the base.
• Verify the sand paper orifices in the sand paper (if any) match
with those in the base. Then, adjust the other edge.
• If the sand paper installed has no appropriate orifices you can
punch them with the hole puncher included. Support properly
the hole puncher. Match the sander base with the hole puncher
and press downwards until the sand paper is punched (B).
• Sand paper shall stay fastened. Otherwise it will be excessively
worn out in the base.
CAUTION Stop operating the machine if the sand paper is
worn or damaged.
Switch On
• Connect the plug into the power outlet.
• To switch on the tool, press the "I" side in
the switch.
• To switch off the tool, press the "O" side in
the switch.
CAUTION Do not switch on the tool
when the sand paper surface is onto the
work piece.
CAUTION
Before switching off the
tool, remove it from the work piece.
Front Handle Adjustment
• The front handle can be adjusted according
to the user's needs.
• To adjust, loosen the handle lock sufficiently
to be able to move it easily into the desired
position.
• Press back the handle lock.
ENGLISH
6

Start Up

Grain Type
60 or lower very rough
80 - 100 rough
120 - 150 medium
180 - 220 fine
240 or higher very fine
A
B

Speed Control

Speed
Control
• Speed can be adjusted to fit the material
to be worked on.
• To adjust speed, turn the variable
speed control dial until reaching the
ON
desired speed.
OFF