Start Up - Truper LIBA-3X21N2 Manual Del Usuario

Start up

Belt set up
1. Pull the belt tension lever until it stops.
2. Choose the abrasive belt with the required grain and set
2
it straight and centered around the rollers. Double check
the arrow in the belt inner side points onto the same
direction that the sander in the belt sander.
3. Push the lever to set it into its initial position.
4. Turn on the sander to make the belt run. While the tool
is running but not making contact with any surface turn the
aligning knob until the belt runs continuously in a straight
1
way.
CAUTION
The belt shall be adjusted tightly to the
sander base. It shall not be loose.
Turn On and operation control
• Intermittent operation: Connect the plug to the power
outlet. Press switch (A) to start the belt sander. To interrupt
using just release the switch.
• Continuous Operation: Connect the plug to the power
3 4
outlet. Press switch (A) and block it by pushing the
continuous use button (B). To stop, press and then release
the switch.
B
Dust collecting
pouch
A
Dust collection
• To prevent dust from accumulating in the belt sander and
the work place use the dust extraction orifice altogether
with the collecting pouch or a vacuum system if needed.
6
ENGLISH