Start Up - Truper LIRO-5A Instructivo

Sanding Disc Selection
• Grains available vary from very coarse to very fine.
• Coarse grain is used to sand rough surfaces, medium grain,
for light work and fine grain is for smooth finish.
• It is advisable to carry out tests over a disposable piece to
determine the adequate grain for a particular job.
• Do not use the same disc for wood and for metal. Metal
particles can get embedded in the sanding and ill-treat a
wooden surface.
Installing a Sanding Disc
WARNING Always double check the sander is off and
disconnected from the power supply before installing the sandpaper.
• Select the right sanding grain.
• Remove dust and debris from the pad and it Velcro base (A).
• Align the sanding disc orifices with the orifices in the pad. Press firmly.
• To remove the sanding disc tear it out from its base (B).
CAUTION • Clean regularly dust accumulated in the Velcro base.
Do not wait for the disc to be completely worn out before replacing it.
Otherwise, the Velcro base can get damaged and will lose adherence
with the sandpaper.
CAUTION • The Velcro base is considered as a consumable and
is not covered by the Warranty.
Switch On
• Connect the plug into the power outlet.
• To start the tool, press switch (C) into the ON position ( I ).
• To shut off the tool, press the switch to the opposite side.
Do not start the tool when the sander surface is onto
CAUTION
the work piece.
CAUTION Before shutting off the machine, keep it away from
the work piece.
6
ENGLISH

Start up

Grain Type
60 or lower very coarse
80 - 100 coarse
120 - 150 medium
180 - 220 fine
240 or higher very fine
A
C
B