Safety System; Before First Use; Using The Appliance - TEFAL ZE3501MX Manual Del Usuario

DESCRIPTION
A Pusher
B
Feed tube
C Cover
D
Sieve
E
Juice collector
F
Pouring spout

SAFETY SYSTEM

To start the juicer, the cover (C)
must be fitted correctly (Fig. 2).
At the end of a cycle, turn the

BEFORE FIRST USE

We recommend that you wash the
removable parts (A, B, C, D, E, F, G,
H) before the first use (see section
"Cleaning and care").

USING THE APPLIANCE

• Place the juice collector (E) on
the body of the appliance (see
Fig. 1).
• Place the sieve (D) in the juice
collector (E). Ensure that the sieve
is properly clipped onto the drive
shaft (K) (see Fig. 1).
• Fit the cover (C) on the appliance,
pulp ejection spout (see Fig. 2).
• Fit the cover (C) on the appliance
in order to have the pulp
evacuation exit to the rear (see
fig.2).
• Lock the two clamps (I) on
G Non-drip spout
H
Pulp collector
I
Safety clamps
J
Control button
K
Drive shaft
L
Motor unit
control button to "0" and wait
until the sieve (D) stops completely
before removing the cover (C).
• Unpack the appliance and
then place it on a solid, stable
worktop, remove the cover (C)
and take out the protective card
on the sieve (D).
the cover (C). You will hear an
audible "click" (see Fig. 4).
• Slide the pusher (A) into the feed
tube (B) aligning the groove on
the pusher with the small ridge in
the feed tube.
• Your appliance is equipped with
a non-drip spout (G). Fit it (spout
downwards) on the pouring spout
(Fig. 5).
• Place a glass under the non-drip
spout in front of the appliance
(see Fig. 5).
• Plug in the appliance.
13