VALERA IONIC COMFORT 613 Serie Instrucciones De Uso página 4

•Always switch off the unit before putting it down.
•After use always switch the unit off and remove the plug from the
power supply socket. Do not pull on the wire to remove the plug from
the power supply socket.
•Do not pull the plug out of the power supply socket when your hands
are wet.
•When using the appliance make sure the air intake and exhaust grilles
are never obstructed. This unit is fitted with a device to guard against
overheating that switches it off immediately when the temperature gets
too high. Should this happen, move the switch to the 0 position and
leave it to cool for 5 minutes.
•Always allow the unit to cool before putting it away and never wrap
the cord around the unit.
•Check that the cord has not been damaged from time to time.
•Do not use your unit if it is not working properly, if it has fallen or if the
cord is damaged. Do not try to repair this electrical unit yourself, rather
contact an authorized technician.
•The elements used to pack the unit (plastic bags, cardboard box, etc.) must
be kept out of reach of children as they are a potential danger to them.
•This unit must only be used for the purposes for which it is expressly
intended. Any other use is to be considered improper and therefore
dangerous. The manufacturer accepts no responsibility for damage
caused by improper or erroneous use.
•Do not use hair spray while the unit is running.
•To avoid dangerous overheating, it is advisable to unwind the entire
length of the cord.
•Warning - The metal parts overheat if used for too long. Be careful and
allow these parts to cool before touching them.
•Do not remove the appliance from the head while switched on: always
set the switch to 0 first.
Important
This hairdryer conforms to the safety regulations regarding electrical appliances.
This hairdryer has a safety cut-out which will operate in case of overheating. The dryer will re-set itself
after being left to cool for a few minutes, but please check air inlet and outlet grills are clear before
continuing to use the dryer.
USE
Position of switch
0 = OFF
C = COOL / warm air
1 = hot air / slow speed
2 = very hot air / fast speed
4