Basic Setup - Doro PhoneEasy 312cs Manual De Instrucciones

Connection
1. Connect the curly cord to the handset and to socket marked
y on the telephone.
2. Connect the telephone line cord to a network wall socket and
to the K socket on the back of the telephone.
3. Lift the handset and listen for the dial tone.
Batteries
This telephone is powered from the telephone line.
If the power from the line is insufficient, you can install four AA
alkaline batteries as backup for the Caller ID and speakerphone.
Use only AA alkaline batteries of good quality.
Note!
Before installing or changing the batteries, make sure that
the telephone is not connected to the telephone network.
1. Disconnect the telephone line cord.
2. Remove the battery cover.
3. Insert the batteries ensuring correct battery polarity is observed.
4. Replace the battery cover and reconnect the telephone line cord.

Basic setup

Before using the telephone the first time, the following basic
settings should be made.
After confirming a setting, the next setting is automatically
displayed. The setup mode will automatically time out after
30 seconds of inactivity. You can exit setup mode anytime by
pressing
Installation
.
English
2