Remote Control Operation - Sanyo DP50747 El Manual Del Propietario

REMOTE CONTROL OPERATION

Œ
Input Key—Press to change the input signal
source as follows: Analog RF ¬ Digital RF ¬
Video 1 ¬ Video 2 ¬ Video 3 ¬ HDMI 1 ¬
HDMI 2 ¬ HDMI 3 ¬ Analog RF.

Number Keys—Two keys must be pressed to
select a direct channel. Example: Press 0 then 6
to select channel 6. (See item #5 below.)
Note: Numerical direct channel selection works for
either Analog or Digital channels in memory but
not both at the same time.
Ž
Info Key—Press to display the Digital and Analog
Full Banner information which includes: Channel
Number (Major and Minor), Tuner ID, Station ID,
V-Chip Program Rating, Program Title, Audio Info,
and Signal Strength, if available. (Press again to
remove the display.)

Recall Key—Press to switch between the last
two channels. The Recall key cannot toggle
between a Digital channel and an Analog channel.

1– – Key—For Analog Cable channels above 100,
press this key, then press the other two numbers.
‘
Menu Navigational Keys:
Menu—Press to display the on-screen menu.
Cursor L (up) M (down) keys—Use these keys
to move the cursor up and down within the menu.
Cursor < (left) > (right) keys—Use these keys to
move the cursor left and right within the menu.
Enter Key—Press to select an option from the
menu system, when required.
Exit Key—Press to exit from the menu system.
’
Caption Key—Press to select mode options:
Digital CC1 ~ Digital CC6, or Analog CC1 ~ CC4,
OFF, or QuikCap.
“
Channel Scanning (CH L M ) Keys—Press to
scan through the channels in memory.
Volume Keys—Press VOL – + to adjust.
”
Pix Shape Key—Use this key to change the video
display format. Available options depend on signal
received and the broadcast's aspect ratio. They
may include: PIX1, PIX2, PIX3, and PIX4.
•
Audio Key—Press to select the desired audio
mode (if available).
11
Note: The Sleep Timer cancels when the TV is turned
12
13
Note: Channel scan memory database of digital and
Need help?
Visit our Web site at
Point toward
DTV
Œ

Ž


‘
’
“
”
•
Sleep Key—Press this key then the "0" key to
set the Sleep Off Timer. Time can be set in 30-
minute increments up to 3 hours.
off or if a power failure occurs.
Mute Key—Press once to mute the sound.
Reset Key—Press this key twice to restore
factory settings. The TV will automatically start
Channel Search and clear all customized settings.
analog channels will be replaced. If desired, per-
sonal settings can be made again using the menu
options.
www.sanyoctv.com
or Call
11
12
13
1-800-877-5032
11