Handling Precautions; Removing The Plasma Stand (Optional); Wall Mounting (Optional); Positioning Precautions - Sanyo DP50747 El Manual Del Propietario

HANDLING PRECAUTIONS

•
Handle the Plasma DTV carefully when
installing. Do Not Drop.
•
Throughout the installation process, handling by
more than two people is recommended.
•
When removing the stand, use a working space
that is larger than the screen size. The work
surface must be flat and covered with a soft
cloth or blanket to protect the screen surface.
•
Before placing the Plasma DTV face down,
make sure there are no objects under the
screen. Leaving any object may cause damage
on the screen surface.
REMOVING THE STAND (Optional)
Tools Needed: Phillips screwdriver
Important Note: Place DTV face down on a
padded or cushioned surface that is larger than
the screen size to protect the screen and
finish. Handling by more than two people is
recommended.
1 Remove four (4) screws from the metal bracket.
CAUTION: Hold the stand firmly as you remove
the last screw.
2 Carefully remove the stand.
4
Need help?
Visit our Web site at
www.sanyoctv.com
or Call

WALL MOUNTING (Optional)

Use the threaded inserts on the back of your Plasma
DTV to secure it using a wall mounting kit.
(UNIVERSAL standard interface 480 x 200 and 480 x
360.)
Note: Wall Mounting kit is not supplied.
Mounting screws measurements: M6 Diameter,
Length—12mm (maximum).

POSITIONING PRECAUTIONS

•
Place this Plasma DTV as indicated here. Failure to
do so may result in a fire hazard. Allowing the
proper amount of space at the top, sides, and rear
of the Plasma DTV cabinet is critical for proper air
circulation and cooling of the unit. The dimensions
shown here indicate the minimum space required.
If the Plasma DTV is to be built into a compartment
or similarly enclosed, these minimum distances
must be maintained.
•
Do not cover the ventilation slots on the Plasma
DTV. Heat build-up can reduce the life of your
Plasma DTV, and can also be dangerous.
•
If the Plasma DTV is not to be used for an extended
period of time, unplug it from the power outlet.

PROTECTING THE PLASMA SCREEN

The screen is likely to be damaged if it is not main-
tained properly. Do not use hard objects such as hard
cloth or paper. Do not use excessive pressure when
cleaning the screen; excessive
pressure can cause permanent
discoloration or dark spots.
NEVER spray liquids on the
screen.
1-800-877-5032