ZUMEX Soul 2 Serie Manual De Instrucciones página 13

Easy to clean,
like everything in Soul
Once the feeder case lid is removed, take out the sweeper unit located
7
in the cutting housing by moving the tab at the far right of the tray and
sliding the whole unit outwards to take it off the guides of the cutting
housing. You will find the screw conveyor and the filter inside this sweeper
unit tray. Take them out. Zumex recommends thorough cleaning of the tap
with the brush supplied. Press the back tab to unclip the Tap and take it
out. To put it back in, position it in front of the tap support holes and fit it
into them.
Take the whole pressing units and shafts unit out by pulling the handle on
8
its central support upwards.
Warning! Take care with the cutting zone!
Take care with the blade when removing the shafts and pressing units
unit.
9
Remove the Waste collection tray to empty the peel.
7
8
EN
9
24