Pin Assignment - D+H DXD 150-K-BSY+ Manual De Instrucciones

Pin Assignment

Connection: Page 18 - 19
* if power is set on L-CLOSED and L-OPEN
simultaneously, the drive opens in HS
Shifting of drive cable
Disconnect drive from electric voltage!
Stroke shortening
For shortening the stroke, the joint pins and magnets
need to be shifted to the desired position with a
proper tool, e.g. a screwdriver. Thereby, the
minimum distance (60 mm and 5 mm) needs to be
satisfied!
After shifting the "CLOSED magnet",
the drive has to close
the window; it will then
automatically be reset
to an new neutral point!
X
8/20
DXD 150/300 -K-BSY+ (-HS)
Standard
GN (Data B)
YE (Data A)
YE/GN (PE)
BU (N)
BN (L - CLOSE)*
BK (L - OPEN)*
2 magnets
joint pin
e t
g n
S
m a
E -
O S
C L
± 2,5mm across all drives)!
N
English
Option -SZ-SA-SGI
GN (Data B)
YE (Data A)
YE/GN (PE)
BU (N)
BN (L - CLOSE)*
BK (L - OPEN)*
GN (-SZ)
GY (-SZ)
YE (-SA)
PK (-SA)
WH (-SGI)
BN (+SGI)
View X
joint pin
- m
E N
O P
S
** programmable with software
SCS and BI-BT2
via Bluetooth
While shorten the stroke witihn
a drive group (2-4 drives), all
magnets needs to be set on the
same measure (tolerance of
99.824.28 1.5/02/16
X
t * *
n e
a g N