Cleaning And Maintenance - Beurer BARBERS CORNER HR 7000 Instrucciones De Uso

Protective cap/three-day stubble attachment
NOTE
Depending on the growth rate of the beard and the shave, three-day stubble can look very different.
To give the appearance of three-day stubble, regularly dry shave with the protective cap/three-day stubble attachment at-
tached. The protective cap/three-day stubble attachment serves as a three-day stubble attachment in this scenario.
Detail trimmer
The foil shaver has an integrated detail trimmer to help you shave or trim neat contours.
To use it, proceed as follows:
1. Slide the detail trimmer completely upwards as shown.
2. Press the ON/OFF switch
3. Start to shave or trim neat contours using the detail trimmer.
4. When you have finished shaving or trimming your contours, switch the foil shaver off. Press
the ON/OFF switch
5. Clean the detail trimmer after every shave using the cleaning brush provided.

9. Cleaning and maintenance

Cleaning the device
WARNING
• Always pull the mains adapter out of the socket before cleaning the device. Risk of electric shock!
• Only clean the housing of the device with a soft cloth dampened with warm water or the cleaning brush supplied.
• Do not clean the device with highly flammable liquids. Risk of fire!
• Do not clean the device in the dishwasher.
• Remove any residual hair from the device after each use.
Use the cleaning brush provided for this task.
• Do not use any aggressive, caustic, abrasive or corrosive cleaning products or hard brushes.
Cleaning the triple-blade shaving system under running water
Clean the device regularly, at the latest once the maintenance indicator symbol (see chapter 6 on device description) lights
up in the display.
To clean the triple-blade shaving system particularly thoroughly, you can also rinse it under running water. To do so, pro-
ceed as follows:
1. Press the shaver unit release buttons on the sides.
2. Pull the triple-blade shaving system from the device in an upward direction.
3. Press the shaving foil release buttons on the sides.
4. Pull the shaving foil upwards to remove it from the device.
5. Hold the triple-blade shaving system under running water so that the jet of water runs through
the shaving foil from the outside in.
6. Once the triple-blade shaving system is completely dry, first place the shaving foil on the tri-
ple-blade shaving system and then place the triple-blade shaving system on the foil shaver as
pictured, until you feel and hear it click into place. During reassembly, ensure that the little re-
cess of the triple-blade shaving system is located above the detail trimmer.
to switch on the foil shaver.
to switch off the foil shaver.
18