Ega Master 57099 Manual De Instrucciones página 15

12. Press and release the trigger several times until grease flows out from the coupler. The
grease pressure can be adjusted by regulating the inlet air pressure. Grease pressure is 40
times greater than the air inlet pressure.
LOADING GREASE GUN USING A FILLER PUMP
NOTE: Always remove any cartridges from the grease gun prior to filling by transfer pump.
1. Wipe the grease gun's bulk loader clean.
2. Make sure that the filler pump is fully primed. Do this by operating the lever handle on the
pump to make sure there is grease discharge.
3. Connect the bulk loader valve on the grease gun to the bulk loader adapter on the grease
gun filler pump. The connection must be tight. If the two do not fit together properly, change
one or both as needed.
4. Operate the pump to fill grease into the barrel. Do not overfill grease as this may result in
grease leaking from the joints.
5. Disconnect the grease gun loader adapter from the filler pump. Slightly loosen the grease
gun head 2-3 turns.
6. Unlock the plunger rod handle from the end cap.
7. Move the plunger rod forward and backward to force out any trapped air pockets from the
grease. Air will escape from the connection between the grease gun head and the barrel,
which is not fully tightened.
8. Reconnect the air supply and "prime" the system by pressing and releasing the trigger until
the grease starts coming out of the discharge nozzle. Initial grease discharge may have
trapped air. Once the gun has been primed, fully tighten the grease gun head onto the
barrel.
9. Push the plunger rod into the barrel for easier maneuverability during use.
10. You should now connect the grease gun extension and coupler onto the grease gun outlet.
The connection between the extension and grease gun must be tight and it is advisable to
use a thread sealant to ensure a leak-proof joint.
Do not apply excessive torque or over-tighten the grease gun extension as this will apply
undue stress to the die cast outlet and may cause it to fracture.
11. Press and release the trigger several times until grease flows out from the coupler. The
grease pressure can be adjusted by regulating the inlet air pressure. Grease pressure is 40
times greater than the air inlet pressure.
GREASING A GREASE FITTING / GREASE NIPPLE
The grease coupler provided at the end of the grease gun extension has a jaw type
construction. The coupler jaws will snap on to a grease fitting and maintain a tight fit. When
connecting the coupler to the grease fitting, press the coupler straight onto the grease fitting to
form a snug fit. Start operating the grease gun with the coupler as square to the grease fitting as
possible.
Once greasing is completed, slightly tilt the coupler, twist and pull back. The tilt and twist
action will allow easy removal of the coupler from the grease fitting.
15