Ega Master 57099 Manual De Instrucciones página 17

CAUTION
- The maximum rating listing as above should not be exceeded.
- This tool should only be used for its designed purpose and according to the instruction in
this manual.
- Do not allow bystanders or children in the work area as they may cause distractions which
may lead to mistakes and accidents.
- Carefully inspect the tool for damaged, loose or missing parts. If the unit is worn or
damaged, do not use it and contact an authorized service center for evaluation or repair.
- The Single Shot Grease Gun must be primed after each refill or grease cartridge change.
You should also check the priming of the gun before each use.
- For best performance and to extend products life, add a few drops of air tool oil through
the air fitting at the bottom of the handle. If gun begins to cycle slowly or erratically, it is
required certainly.
1. Remove the gun head from the container tube.
2. Draw back the plunger handle completely.
3. Insert open end of cartridge into the container tube and push all the way in. Remove the
seal or pull tab end from the cartridge.
4. Reassemble the gun head to the container tube. Press the catch plate and release the
piston rod. Pull down the plunger handle.
1. Remove the gun head from the container tube.
2. Submerge open end of the container tube into grease bucket about 2" deep
and pull the plunger handle out slowly and engage rod into key slot.
3. Reassemble the gun head to the container tube. Press the catch plate and
release the piston rod. Pull down the plunger handle.
1. Draw back the plunger handle completely.
2. Insert the filler plug on the gun head into the valve on the pump.
3. Operate the pump until the container tube is full of grease.
4. Remove the filler plug from the valve on the pump.
5. Press the catch plate and release the piston rod. Pull down the plunger
handle.
CARTRIDGE LOADING
SUCTION FILLING
FILLER PUMP FILLING
17