ABB RS 232/FO Manual De Operación

212117 041001
ILPH Optical Fiber
1
2
3
4
5
RS232 / FO
Version 3.0 07.03
M L K
J H G
D E F
A B C
Serial link interface
RS 232 / Optical Fiber
Operating manual
The device must be installed by a qualified engineer.
Set-up and configuration:
LED „U"
1
Power supply status
Optical Fiber emitter
2
ST connector for glass fiber optic
FSMA screw connector for plastic optical fiber
3 LED „TD"
Data transmission status
Optical Fiber receiver
4
ST connector for glass fiber optic
FSMA screw connector for plastic optical fiber
5 LED „RD"
Data reception status
Connections:
1 RS 232
Connections:
Data input
Data output
Signal ground
Shield
Technical data:
Standard:
Transmission speed:
Transmission distance:
2 Optical Fiber
Connections:
Optical Fiber emitter
Optical Fiber receiver
Technical data:
Fiber type:
Connections: Glass:
Plastic:
Wave length: Glass:
Plastic:
Max. transmission power:
Glass 50/125 µm:
Glass 62,5/125 µm:
Plastic 980/1000 µm:
Min. reception sensitivity:
Glass 50/125 µm:
Plastic 980/1000 µm:
Max. transmission distance:
Glass 50/125 µm:
Glass 62,5/125 µm:
Plastic 980/1000 µm:
3 Power supply
Connections:
Power supply voltage
Power supply voltage
Protective earth
Shielding terminals
Operating voltage:
See the label on the product
Voltage
24.. 42VAC/DC
110..240VAC/DC
English
RxD - terminal L
TxD - terminal M
0V - terminal K
SH - terminal G
EIA RS 232C; CCITT V.24/V.28
max. 115,2kbits/s
max. 15m
Multimode fiber
ST connector
FSMA screw connector
820nm
655nm
-14,4dB/m
-14 dB/m
- 8 dB/m
-28 dB/m
-20 dB/m
3km
4km
40m
~/+ - terminal B
~/- - terminal C
- terminal A
- terminals D, E, F
Tolerance Frequency
-15%..+10% 50/60Hz
-15%..+10% 50/60Hz