Broan ALLURE QS3 Serie Manual De Instrucciones página 3

PREPARE THE HOOD
BOTTOM
COVER
(Held in
place with
2 screws)
3 Remove Bottom Cover from hood. Set cover and mounting
screws aside.
4 Remove Damper/Duct Connector from inside the hood.
Set connector aside - with mounting screws and parts bag.
5 Remove either top or back wiring knockout and install
approved Electrical Cable Clamp.
®
(Continued)
DAMPER/
DUCT
CONNECTOR
ELECTRICAL
CABLE CLAMP
PREPARE THE HOOD
NOTE If hood is to be installed Non-Ducted:
•
Purchase a set of (2) Non-Ducted Filters from your
local distributor or retailer and attach them to the
aluminum mesh filters.
•
Skip to Step 9 section on page 4.
TOP RECTANGULAR
DUCT KNOCKOUT
(Remove for 3¼" x 10"
Vertical & for 7" Round
Discharge)
REAR
RECTANGULAR
DUCT KNOCKOUT
(Remove for 3¼" x 10"
Horizontal Discharge)
6 Remove appropriate Duct Knockout(s) from top or back of
hood.
®
ALLURE QS3 SERIES
RANGE HOOD
Page 3
(Continued)
SEMI-CIRCULAR
DUCT KNOCKOUT
(Remove for 7" Round
Discharge)