Address Assignment - Festo VMPA-ASI-EPL-4E4A-Z Serie Manual De Instrucciones

3.5 Address assignment

Before connecting to the AS-Interface bus: assign an unused
address to the slave.
Note
Valve terminal type VMPA-ASI-...-4E4A-Z contains one
AS-Interface slave.
– Permitted address range: 1 ... 31 (factory setting: 0).
– It is not necessary to parametrize the AS-Interface
slave.
Address the valve terminal at the plug "AS-i In" (see sec-
tion 3.7).
The diagram below shows the assignment of the data bits
to the inputs and outputs of the slave:
Data bits:
Inputs:
Outputs:
I/O = Bidirectional (B)
The address mapping depends on the configuration of the
master.
24
Slave: IO code 7
D0 D1 D2 D3
I/O I/O I/O I/O
I0 I1 I2 I3
O0 O1 O2 O3
Festo P.BE-K-MPA-ASI-4E4A-Z 1109b English
H