Set Profisafe Address - Festo CPX-FVDA-P2 Traducción Del Manual De Instrucciones Original

CPX-FVDA-P2

Set PROFIsafe address

For communication via PROFIsafe, the correct PROFIsafe address must be set bin-
ary coded at the output module via the 10-element DIL switch (
ible are the PROFIsafe addresses in the range from 1 to 1023.
The 10-element DIL switch is located directly on the electronics module and can be
set with a dismantled connection block.
10-element DIL switch
Fig. 2:
Note
The DIL switch is a mechanically sensitive component due to its size.
S To set it, use an appropriate, small dull too (e.g. watchmaker's screwdriver)
and proceed very carefully.
1. Switch off the power supplies for the CPX terminal.
2. Remove the mounted connection block (
3. Set the DIL switch as carefully.
4. Mount the connection block again (
Festo CPX-FVDA-P2-Z6 1209NH English
1
2
4
8
16
32
64
128
256
512
10-element DIL switch of the electronics module
Addressing examples
2 + 64 + 512 = 578
Fig. 1).
mounting of the electronics module).
Fig. 2). Permiss-
45