Address Assignment Of The Valve Solenoid Coils - Festo CPA-VI-MP Serie Manual De Instrucciones

3.2 Controlling the valve terminal
Always control the valve terminal in a uniform mode. Pre-
ferably with all control signals positive-switching
(1-switching) or all control signals negative-switching
(0-switching). Control in mixed mode is not permitted.

3.3 Address assignment of the valve solenoid coils

– Addresses must be assigned in ascending order, from
left to right, on the individual valve locations from the
rear to the front.
– A valve location occupies 1 (CPA...-EV1) or 2 (CPA...-
EV2) addresses depending on the sub-base block. If a
sub-base block occupies 2 addresses, the following
assignment applies:
– pilot solenoid 14 occupies the lower-value address,
– pilot solenoid 12 occupies the higher-value address.
A certain pin on the multipin plug is assigned to each valve
coil for controlling the valves.
14 Festo CPA..-...-VI-MP-... 0208a English