Safety Instructions - EGAmaster EGATronik 51664 Manual De Instrucciones

• Response time for capacitance measurement: less than 3s for ≤1mF; about 6s for ≤10mF;
about 8s for ≤60mF.
• Full-featured false detection protection for up to 600V (30kVA) energy surge; overvoltage
and overcurrent alarm functions.
• The power consumption of the meter is about 1.8 mA. The circuit has an automatic power
saving function. The consumption in sleep state is <11uA, which effectively extends the
battery life to 400 hours.
Warning
Before using the meter, please read the Safety lnstructions carefully.
The meter is designed according to EN61010-1, 61010-2-032/033 and electromagnetic
radiation proteclion EN61326-1 safety standards, and conferms to CAT II 600V, CAT III 300V,
double insulation and pollulion grade II.
Note
In case the meter is not used in accordance with the operating instructions, the protection
provided by the meter may be weakened or lost.
1. Before use, please check if there is any item which is damaged or behaving abnormally.
lf any abnormal item (such as bare test lead, damaged meter casing, broken LCD, etc.) is
found, or if the meter is considerad to be malfunctioning, please do not use the meter.
2. Do not use the meter if the rear cover or the battery cover is not covered up, or it will pose a
shock hazard!
3. When using the meter, keep fingers behind the finger guards of the test leads, and do not
touch exposed wires, connectors, unused inputs, or circuits being measured to prevent
electric shock.
4. The function switch should be placed in the correct position before measurement. lt is
forbidden to changa the position during measurement to avoid damage to the meter!
5. Do not apply voltage over 600V between any meter terminal and earth ground to prevent
electric shock or damage to the meter.
6 Be cautious when the measured voltage is higher than 60V (DC) or 30Vrms (AC) to avoid
electric shock!
7. Never input voltage or current which exceeds the specified limit. lf the ranga of the
measured value is unknown, the maximum ranga should be selected.
8. Before measuring the resistance, diode and continuity online, switch off the power supply of
the circuit, and fully discharge all capacitors to avoid inaccurate measurement.
9. When the
ensure measurement accuracy. lf the meter is not in use for a long time, please remove the
batteries.
10. Do not change the intemal circuit of the meter to avoid damage to the meter and user!
11. Do not use or store the meter in high temperatura, high humidfy, flammable, explosiva or
strong magnetic field environments.
12. Clean the meter casing with a soft cloth and mild detergent. Do not use abrasives or
solvents!

SAFETY INSTRUCTIONS

symbol appears on the LCD, please replace the batteries in time to
17