Getting Started; Powering The Unit - Waterpik WF-06 Manual Del Usuario

6

GETTING STARTED

Fill
ON
OFF
O
I
Align
1. 2.
Align
3. 4.
1. 2.
High
ON
OFF
Water ON

Powering the Unit

Plug the cord into an electrical outlet. If the outlet is controlled
by a wall switch, be sure it is turned on.
Preparing the Reservoir
Remove the reservoir lid, remove the reservoir from base, and
fill with lukewarm water. Replace the reservoir onto the base,
press down firmly, replace reservoir lid.
Inserting and Removing Tips
Tip Insertion
1. Press top button on handle to release flip top.
2. Insert tip through top, align notches on tip and handle
(dots on tip and flip top will align).
3. Using thumb, press tip firmly into opening to click into place.
4. Close flip top. Check to ensure top is secured to handle prior
to
water flossing.
Tip Removal
1. Press top button on handle to release flip top.
2. Firmly push tip through opening to click out of position.
Prime Unit (First Time Use Only)
Set pressure control dial on base to high (pressure setting
No.10), point the handle and tip into sink. Turn power and water
ON until water flows. Turn water and power off.
NOTE: A tablet does NOT need to be loaded into handle
or priming.