Getting Started - Waterpik WP-400 Serie Manual Del Usuario

6 6

GETTING STARTED

Fill
Eject
Pressure
Setting
Important! Turn Water Flosser off and charge for 24 hours before first use. Plug the
cord into any standard electrical outlet. Make sure you push the switch into the OFF (0) position
before charging. The unit will not charge if the switch is in the ON (I) position. See "Cleaning and
Troubleshooting Your Waterpik® Water Flosser" for guidance on how to look after your battery. The
Waterpik® Water Flosser will stay charged for up to 2 weeks depending on use.
Filling the Reservoir
Disconnect charging cord from the unit prior to filling the reservoir and product use. Lift flip top on
reservoir and fill the reservoir with lukewarm water.
Inserting and Removing Tips
Insert tip into the center of the knob at the top of the Water Flosser handle. The colored ring will be
flush with the end of the knob if the tip is correctly locked into place.
To remove the tip from the handle, press the tip eject button and pull tip from the handle.
CAUTION: Do not press tip eject button while unit is running.
Adjusting the Pressure Setting
You can adjust the pressure setting on your Water Flosser by simply sliding the pressure switch on
the handle.