Publicidad
Idiomas disponibles
Idiomas disponibles
• Never have a lighted flame under the extractor hood.
• The appliance must be placed in such a way, that the supply
plug is accessible.
• The hood must be installed at a minimum distance of 65cm
from the stovetop.
• During climatic conditions causing electrical interference, it is
possible that the device may stop working. By switching the
device OFF and ON the device will resume normal operation
safety.
• This hood is not designed to be used by people (including
children) with reduced physical, sensorial or mental capacity,
or who lack experience or knowledge about it, unless they
have had supervision or instructions on how to use the hood
by someone who is responsible for their safety.
• Children must be supervised to ensure that they do not play
with the hood.
• The evacuated air must not be sent along conduits that are
used to evacuate smoke from devices powered by gas or other
fuels (this does not apply to devices used exclusively to dis-
charge air inside the room).
• When the extractor hood is turned on at the same time as
other appliances powered by energy other than electricity, the
air outlet must not be greater than 4 Pa (4x10-5 bar).
• Never use the hood in places where appliances are already
operating with outputs connected to the exterior unless per-
fect ventilation of the place can be ensured.
• This hood can only be installed over electric or gas hobs
with a maximum of 4 cooking points.
• If the extractor hood is installed over a gas cooking applian-
ce, the minimum distance between the surface supporting the
cooking elements and the lower part of the hood must be at
least 65 cm. If the installation instructions for the gas cooker
indicate a greater distance, this should be observed.
• If the extractor hood is installed over an electric cooking
appliance, the minimum distance to be left between the surfa-
ce supporting the cooking elements and the lower part of the
hood is described in the assembly plan.
• The regulations with respect to air evacuation must be res-
pected.
MAINTENANCE
-Cleaning.
Before any type of operation, always make sure that the elec-
trical cord is disconnected and the switch is in the off position.
Clean the external part with a mild, liquid detergent and avoid
the use of abrasive cleaning products.
-Changing the light.
Before changing the light make sure that the hood is not con-
nected.
Remove the grease filter and replace the light with a light bulb
no more powerful than that specified in the Technical
Characteristics. Place the filter in position.
-Cleaning the grease filter.
Depending on use, and at least once a month the grease filters
should be disassembled and cleaned in a dishwasher or with
hot soapy water.
If washed in a dishwasher, the filters should be placed in an
upright position to prevent food remains from falling on them.
After rinsing and drying, replace the filters by following the
steps for disassembly in reverse order.
The active carbon filters must be replaced periodically to work
properly, at least once every three months (depending on the
frequency with which the hood is used).
IMPORTANT WARNING FOR EXTRACTOR HOODS WITH
HALOGEN LAMPS
If the halogen lamps need replacing, they must be replaced by
lamps with an aluminium reflector, never dichroic lamps, to
avoid unnecessary overheating in the lamp holders.
THE MANUFACTURER WAIVES ALL LIABILITY FOR FAILURE
TO OBSERVE THE INSTRUCTIONS FOR THE APPROPRIATE
INSTALLATION, MAINTENANCE AND USE OF THE
EXTRACTOR HOOD.
The manufacturer declares that this product meets all the
essential requirements for low voltage electrical material set
out in European directive 2006/95/EEC of 12 December 2006
and for electromagnetic compatibility as required by European
directive 2004/108/EEC of 15 December 2004.
If you need any technical help or would like more information
about our products, please do not hesitate to contact our
official distributor.
THE MANUFACTURER reserves the right to effect any techno-
logical improvement or modification without prior notice.
Publicidad
