Removing The Drawer; Replacing The Drawer; Service; Data Plate - Thermador WD24 Instrucciones De Seguridad

Removing the drawer

Replacing the drawer

Service

The Data Plate
WARNING: To prevent burns, do not remove drawer while hot. Be sure
drawer is drawer is empty before removing.
Figure 5: Removing the Drawer
1) Pull drawer to fully open position
2) Lift up left release lever and press down on right release lever.
3) Firmly pull the drawer outward until each Drawer Rail pulls free from each
Inner Cabinet Slide. Retract Cabinet Rails while drawer is being cleaned.
1) Be sure Cabinet Rails are pushed inside cabinet.
2) Align each Drawer Rail to each Inner Cabinet Slide. Use the Slide Lock to
guide placement.
3) Close the drawer completely; the Slide Lock will secure the drawer.
4) Pull out drawer fully to check that both locks are engaged.
For repair or service, contact an authorized technician through any of the following
methods:
1) Contact the factory authorized service agent in your area
2) Contact the dealership where you purchased the appliance
3) Call the Customer Support Center (see contact information at the front of this
manual)
4) Write the Customer Support Center (see contact information at the front of
this manual)
The data plate is visible on the left side of the drawer casing. Remove the drawer
to view it.
English 7