Base Station; Starting Signal Reception - ADE WS 1822 Instrucciones De Operación

Base station

1. Push the locking tab down slightly and remove the
battery compartment cover.
2. Insert 3 batteries of type LR03 (AAA)/1.5 V as depicted
on the bottom of the battery compartment. Pay
attention to the correct polarity (+/-).
3. Replace the battery compartment cover and snap it
shut.
4. Wait approx. 30 minutes. The base station requires this
time to collect all weather data and to receive radio
signals from the time signal transmitter.

Starting signal reception

When the base station is energised, all displays are shown
for a brief moment. Furthermore, the display is briefly lit up
and a beep sounds.
The device then switches to receiving-mode,
during which the number of radio waves indicates
the quality of the reception: The more radio waves
shown on the display, the better is the reception.
During wireless reception by the time signal transmitter,
the buttons are disabled (except
As soon as the signals from the time signal transmitter and
wireless outdoor sensor have been received in sufficient
strength, the respective data is permanently shown in the
display.
Weather Station with Wireless Outdoor Sensor WS 1822
).
49