KTM RACING BUBBLE Guia De Incio Rapido página 5

Scope of supply

Windshield
NOTE:
All screws and blind rivets are reused with the original wind-
shield.
Before assembly, these parts must be cleaned thoroughly.

- Remove screws .
- Remove both rear view mirrors and disconnect the plug-in
connection.
Assembly torque: 9 Nm
Repeat the following steps on the opposite side:

- Remove blind rivets .
- Take off the side cover.

- Remove screws .
Assembly torque: 7 Nm

- Remove screws with the washers.
- Take off the original windshield.
90508965000
5