Water Inlet - Electrolux EWF 127410 X Manual De Instrucciones

24 electrolux
2. Remove the power supply cable and
the draining hose from the hose holders
on the rear of the appliance.
3. Unscrew the three bolts.
4. Slide out the relevant plastic spacers.
5. Open the porthole. Remove the poly-
styrene block fitted on the door seal.
Remove from the drum the objects
supplied with the machine.
6. Fill the smaller upper hole and the two
POSITIONING
Install the machine on a flat hard floor.
Make sure that air circulation around the
machine is not impeded by carpets, rugs
etc. Check that the machine does not
2
1
touch the wall or other kitchen units. Level
the washing machine by raising or lowering
the feet. The feet may be tight to adjust as
they incorporate a self locking nut, but the
machine MUST be level and stable. If nec-
essary, check the setting with a spirit level.
Any necessary adjustment can be made
with a spanner. Accurate levelling prevents
vibration, noise and displacement of the
machine during operation.

WATER INLET

An inlet hose is supplied and can been
found inside the machine drum. Do not use
large ones with the corresponding plas-
tic plug caps supplied in the bag con-
taining the instruction booklet.
Caution! Never place cardboard,
wood or similar materials under the
machine to compensate for any
unevenness in the floor.