Leveling Your Washer; Connecting Inlet Water - Electrolux EFLS210TIS Instrucciones De Instalación

8
Installation Instructions

Leveling your washer

Excessive noise and vibration can be prevented by properly
leveling the washer.
1 For free standing installation and with the washer within
4 feet (1 m) of its final location, place a level on top of the
washer.
2 Use adjustable pliers to adjust the leveling legs so the
washer is level front-to-rear and side-to-side, and stable
corner-to-corner.
3 Press down on alternate corners and sides and feel for
the slightest movement. Adjust the appropriate leg(s)
so the washer sits solidly on the floor on ALL four legs.
Keep the leveling leg extension at a minimum for best
performance of the washer.
NOTE
For pedestal installations, see additional installation
instructions included with the pedestal.

Connecting inlet water

1 Run some water from the hot and cold faucets to flush
the water lines and remove particles that might clog the
water valve screens and to determine which faucet is hot
and which is cold supply.
RUBBER WASHERS
MUST BE PRESENT
NOTE
Hoses are not included with washer purchase. See
"Accessories" section for various inlet hose kits to fit your
specific installation.
2 Connect the HOT inlet hose to the HOT inlet connection
on the washer and the COLD inlet hose to the COLD inlet
connection on the washer. Tighten by hand until snug.
Then tighten each supply connection another 2/3 turn
with pliers. Do not cross thread or over-tighten these
connections.
3 Connect the HOT inlet hose to the HOT water supply and
the COLD inlet hose to the COLD water supply. Tighten
by hand until snug. Then tighten each supply connection
another 2/3 turn with pliers. Do not bend, kink or pinch
water inlet hoses.
4 Turn on the water and check for leaks.
USE ONLY
NEW HOSES
COLD
a
c
a
c
HOT
e
g
b
lower
raise
d
b
d
HOT
COLD
f